Paper Infomation
Establishment of integration curriculum on the Theory and Practice of “Technological Fundamental of Mechanical Manufacturing”
Full Text(PDF, 49KB)
Author: Shiquan Zhou, Zhiyong Li, Yi Zhao, wene Chen, Qing Yang
Abstract: The paper bases on analysis and research of the comprehensive curriculum construction on both of domestic and abroad, the guiding ideology is put forward on the construction of the integration curriculum - theory and practice of "Technological Fundamental of Mechanical Manufacturing", and the course system and teaching content are designed. Through the course knowledge lecturing - basic process practicing, process principle and process design and classroom discussion - project designing and implementation practices, the law of cognition of practice-theory-practice again is realized. On this basis, the integrated textbook of "Technological Fundamental of Mechanical Manufacturing" will be written and published, so as to providing theoretical guidance and implementation plan for the curriculum teaching pilot.
Keywords: Curriculum construction; the integration curriculum of theory and practice; practice-theory-practice again; the integrated textbook
References:
[1]Lin Pinghua. “Conceiving of Engineering practice and experimental teaching system reform” [J], China University Teaching, 2002 (9): 20-21
[2]The department of mechanical engineering University of Waterloo: “Introduction to Mechanical Engineering Practice1-2” http://www.ucalendar.uwaterloo.ca/1617/COURSE/course-ME.html#ME100S
[3]Tong Yongxiang, Jiang Shuyong, Wu bin.” The Application of Case Tteaching for Mechanical Manufacturing Fundamental Course” [J], Higher Education Forum, 2010 (7): 71,112
[4]Zhou Shiquan, Yang jiajun, Lin Pinghua et al. “Project -Based Teaching model research” [J], Science & Technology Information, 2010 (1): 171-173
[5]Serope Kalpakjian, Steven R Schmid. “Manufacturing Engineering and Technology” [6E M], published by prentice Hall 2010; USA